S2 7.9 Meter Class Association

And don't forget to dry it out!

SAWALT, I believe the old forums had a considerable amount of advice on this topic with several approaches to accessing the keel depending on available equipment. I had extensive leading edge and trailing edge cracks after I acquired my boat. I do not trailer but my boat stands are short (so not muc...

Quinn, That is not normal movement of the bulkhead that the starboard chain plate is mounted to; something has come loose. Recommend inspecting your hull in that area for delamination -- I am assuming the bulkhead is laminated on the inner layer of the hull. In fact, it might be worth investigating ...

I forwarded copies of the rudder and keel lines that I had previously downloaded.
G Rehe
Valkyrie #433

I recall seeing info regarding spreaders on the old posts.
You might want to scan those at:
http://www.boatsit.com/discus/messages/106/106.html

I am replacing the stuffing box with the PSS Shaft seal so I thought I would replace the cutlass bearing while I was at it. I removed the two set screws from the side of the strut, some WD 40 and a torch to heat up the strut a couple of times.... proper sized pipes with a long bolt to press the old ...

Bob, I special ordered through West Marine. I ordered the standard speed unit for 3/4 inch shaft and 1 3/4 inch log. The part number #01034134 (note 01 for standard, 34 for 3/4 shaft, 134 for 1 3/4 Log). Be sure of your shaft and log dimensions. The unit is of the same length as the original stuffin...

I just bought a PSS Shaft seal. Will be installing soon, so no performance feed back yet. I was impressed enough with the item to spend the money. Will let you know as the season progresses. I also sent my Martec prop to the manufacturer for refurbishing. Came back looking like a new one. Will let y...