Mast Specs

dopierce · Post by **dopierce** » Mon Nov 07, 2005 10:48 pm

Does anybody have specifications on the replacement mast? I need new standing rigging and want to get it right. I'm especially concerned how far up the mast the slot is for the upper stays.

Dave

Post by **Tom Elsen** » Tue Nov 08, 2005 11:33 am

Hey everyone

I need a couple of people to take this measurement for Dave.

If you have access to your boat, would you please measure the exact distance from the base of the mast extrusion (that is, the bottom end of the tube not the bottom end of the half moon fitting) up to the male portion of the fitting of the spreader bracket (not the collar, the fitting on the collar).

dopierce · Post by **dopierce** » Tue Nov 08, 2005 1:42 pm

...actually I need the measurement to the point well above the spreaders, about 3' down from the top, where the upper stay attaches to the mast. There is a elongiated hole there for the T-fitting on the stay to slide into.

Thanks!
Dave

Sorry Dave. I misunderstood the email you sent to me.